Deling Electron SD-436 Installation Instructions Download Page 1

SD-436 INSTALLATION INSTRUCTIONS

Thanks for buying the Deling photoelectric smoke alarm. Read all instructions before

installing the smoke alarm, so it will protect your home in the best possible way.

● If you are installing the smoke alarm for some other person, leave these instructions

or a copy of them with him/her.

● The Deling photoelectric smoke alarm is also suitable for use in a travel

vehicle,such as camper vans, caravans, and boats.

1.

POSITIONING THE SMOKE ALARM

Place at least one smoke alarm per 60

on each floor.

● Place a smoke alarm in each corridor and bedroom.

● The smoke alarm is to be placed on the ceiling in such a way that it is in the middle

of the room.

● Place a smoke alarm at the top of each staircase.

AVOID THESE POSITIONS:
Near a wall or corner:

Place the smoke alarm at a distance of at least 50cm from a wall or

corner.

Moist places:

Avoid installing smoke alarms near moist or occasionally moist places such

as immediately close to a shower or kitchen, where steam can cause false alarm.

Ventilation ducts:

Avoid installing a smoke alarm immediately next to a ventilation duct.

The draft may prevent smoke from reaching the smoke alarm. Smoke alarm can't be

installed in the location where the air velocity is more than 300 f/min (1.5 m/sec).

Dead

-

air spaces:

Avoid installing a smoke alarm in the angle of a pitched roof. Install it at

a distance of least 10cm from the ridge.

Fluorescent lamps:

Avoid installing a smoke alarm immediately next to fluorescent

lamps,such as halogen lights.

Radiation heating source:

Avoid installing a smoke alarm near radiant heating source,

such as radiant heating in the ceiling can create a hot air boundary layer along the ceiling

surface, which can seriously restrict the movement of smoke and heat to a smoke alarm.

2.

OPERATION ANDTESTING

Alarm mode:

The red light flashes once ever

y 40 seconds in normal mode. When the

smoke alarm detects smoke, it goes into an alarm mode in which the smoke alarm

beeps continually and red light flashing.

Test mode:

The entire surface works as a test button.Press the test button of the

smoke alarm for more than 1 seconds, until you hear the alarm sound and see light

flash.

Silence mode:

During alarm mode, pressed the test button for 1 seconds, the smoke

alarm is immediately reset out of the alarm condition and the beep is silenced when

the test button is released the device enters into a 9-minute silence mode. In silence

mode, the red light flash once every 0.6 seconds to indicate that the mode is

active.The silence mode will be cancelled if any of the following conditions exist:

● high smoke lever.  ● test button is activated again.

Error mode:

The smoke alarm sends out 'beep' two times every 40 seconds.

Removed the smoke alarm from the mounting plate and clean up the surface

dust,then install the back.If the smoke alarm is still in an error mode, contact the

importer or manufacturer.

Low battery:

When the battery is used up, the smoke alarm beeps at intervals of 40

seconds.

3.

MAINTENANCE

Battery life:

The smoke alarm contains 3V lithium battery (CR123A).Their life time

is10years.When the battery is used up,the smoke alarm beep at intervals of 40

seconds for at least 30 days.If the battery is used up,

replace smoke alarm as soon as possible.

Warning:

Lithium batteries can explode or cause burning if they are inst

alled

incorrectly. User is not recommended to replace batteries.

Clean the smoke alarm at least once a year: Separate the smoke alarm from the

installation plate by turning it counter clockwise.Separate the smoke alarm

carefully.Test the smoke alarm after cleaning it.

Do not paint or modify the smoke alarm !

Waste handing:The smoke alarm should be disposed in accordance with

normal waste handing for electronics.

4. TECHNICAL INFORMATION

Operating principle:Photoelectric  Warranty: 5 years

Alarm current: < 200mA         Voltage: 3V (built-in lithium battery)

Quiescent current: < 7uA        Operating temperature: 0

~ 50

Sound volume: ≥ 85 dB at a distance of 3 meters

Dimensions: 42.5 × Φ50.8mm    Weight: 54 g

Maximum humidity: 93%         Conform to the standard: EN14604

5. GUARANTEE

Deling grants a 5 years guarantee,starting from the purchase date of the product. If

the smoke alarm becomes defective during the guarantee period, the smoke alarm

will be replaced with a new one if the defective one is sent to Deling.The guarantee

covers manufacturing or material defects in the product, if the smoke alarm has been

Summary of Contents for SD-436

Page 1: ...more than 1 seconds until you hear the alarm sound and see light flash Silence mode During alarm mode pressed the test button for 1 seconds the smoke alarm is immediately reset out of the alarm condition and the beep is silenced when the test button is released the device enters into a 9 minute silence mode In silence mode the red light flash once every 0 6 seconds to indicate that the mode is act...

Page 2: ... if it the guarantee receipt is missing The guarantee does not cover costs due to installation or battery replacement Deling responsibility does not in any case exceed the price of a new smoke alarm Deling is not responsible for any damage or loss that has been caused by a non working smoke alarm or negligence by the manufacturer This guarantee does not affect rights enacted by law 6 PRODUCT COMPO...

Page 3: ...ges kitchens furnace rooms or bathrooms INSTALL AT LEAST 15 FEET AWAY FROM ANY FUEL BURNING APPLIANCE Do not install within 3ft 0 9m of the following The door to a kitchen or a bathroom that contains a rub or shower forced air ducts used for heating or cooling ceiling or whole house ventilating fans or other high air flow areas Avoid excessively dusty dirty or greasy areas Dust grease or household...

Page 4: ...e Battery Replacement If battery failure is detected the unit will chirp one time This cycle will occur once every 30 seconds CAUTION YOUR ALARM IS SEALED AND THE COVER IS NOT REMOVABLE To replace the battery you could open the battery door then you can directly replace the battery After installing or changing the battery Test your alarm by using the test button and check that the red LED flashing...

Reviews: