Exterior top
is one-piece 22-gauge stainless steel with
integral 2.12” (5.4cm) square nosing on the front. Top of
drawer unit has openings to accept 8 or 12 1/6-size 4”
(10cm) deep plastic pans. Top of door unit has openings
to accept 8 or 12 1/6-size 4” or 6” (10cm or 15cm) deep
plastic pans. Adapter bars and 1/6 pans are supplied by
Delfield. Lid is constructed of 20-gauge stainless steel.
Temperature in top opening to maintain 33°F (1°C) to
41°F (5°C), with pans recessed 2.5” (6.4cm) at 86°F ambient
room temperature, meeting NSF 7 requirements. One 48” x
10” x .5” (121.9cm x 25.4cm x 1.3cm) polyethylene cutting
board treated with antimicrobial agent is mounted on the
top at the front edge.
Dual level pan brackets
allow the pans to be lowered
an additional inch in the unit without tools to provide
additional pan temperature holding performance.
Exterior back and bottom
are two-piece 24-gauge
galvanized steel. Exterior ends are stainless steel.
Interior sides
are thermoformed ABS plastic with integral
shelf supports. Base is fully insulated with high-density
foamed in place environmentally friendly, Kyoto Protocol
Compliant, Non ODP (Ozone Depletion Potential), Non
GWP (Global Warming Potential) polyurethane.
Refrigeration
system uses hFC-404A refrigerant.
Compressor is 1/5 h.P., with condenser coil and hot gas
condensate evaporator mounted on rear of the cabinet.
Evaporator coil is located on the interior rear wall of the
cabinet. Refrigerant flow is controlled by a capillary tube.
Cabinet maintains an interior cabinet temperature of 36°F
to 40°F (2°C to 4°C).
ACT control:
ACT electronic, solid state control, mounted
on the exterior rear of the cabinet, allows unit to maintain
precise temperatures in heavy duty conditions.
Electrical
connections are 115 volt, 60 hertz, single
phase. Unit has a 6’ (1.8m) long electrical cord and NEMA
5-15P plug.
Specifications
UC4448N Salad Top
Reduced Height Front-Breathing Self-Contained Salad Top Refrigerated Bases
Casters:
Equipment is mounted on 3” (7.6cm) diameter
plate casters with front two locking. Equipment clearance
above the floor is 0.66” (1.7cm).
Doors
have a 24-gauge stainless steel exterior, with
thermoformed ABS plastic interior liner. Cabinet of door
models has one adjustable epoxy-coated wire shelf.
Drawers
have a 24-gauge stainless steel exterior with
thermoformed ABS plastic interior liner. Drawer frames
are 12-gauge stainless steel. Drawer slides are 11-gauge
stainless steel with Delrin bearings. Each top drawer holds
one full size 12” x 20 (30.5cm x 50.8cm) pan and three
1/9 size pans 4”- 6” (10.2cm - 15.2cm) deep. Each bottom
drawer holds one 12” x 20 (30.5cm x 50.8cm) pan and
three 1/9 size pans 4” (10.2cm) deep. Pans are supplied
by others.
980 S. Isabella Rd.
Mt. Pleasant, Michigan 48858
Phone: 800-733-8948 or 989-773-7981
Fax: 800-669-0619
www.delfield.com
Printed in the U.S.A.
DSUC4448N-S
04/11
