6000XL Series Service and Installation Manual
7
For customer service, call (800) 733-8829, (800) 733-8821, Fax (888) 779-2040, www.delfield.com
Delfield
™
®
Some cabinets may weigh over 1000 lbs (450 kg).
Use a lifting device capable of supporting the unit
when removing skid or installing legs or casters.
To install the legs, or casters refer to Figure 1 and proceed as
follows:
1. Remove unit from skid.
2. Raise unit to access leg/caster mounting bolts on bottom
of unit.
3. Remove the bolts from the cabinet and use them to attach
the legs or casters.
All single-section units require that the swivel
casters be mounted on the front and rigid casters
be mounted on the rear.
Leg & Caster Installation
Figure 1. Leg or Caster Installation
WARNING
Door Reversal Procedures
Standard Edge-Mount Hinge
1. Open door 90˚ and lift door straight up and off hinges.
2. Remove the metal screw covers on each door-side hinge
section by sliding it down and off.
3. Remove two outer screws that mount each hinge to door,
loosen the center screw, rotate hinge 180˚, reinstall outer
screws and retighten center screw.
4. Remove two screws that mount lock on top of door, turn
door up-side-down and remount lock to top of door.
5. Use a 3/16” drill to drill holes in cabinet face frame at the
marked hinge locations on the new hinge side.
6. Remove the cabinet hinge screw covers by gently prying
them out with a small screwdriver.
7. Remove all three screws from each hinge and mount them
to the opposite side of the door opening.
8. Remove the plastic cam from the hinges by pulling straight
up, then rotating the cam 180˚ and pushing back into the
hinge.
9. Remount the door and check for proper closure and gasket
seal. Adjust hinges as needed. Once adjustment is verified,
remove the door, reinstall all hinge screw covers and set the
door back in place.
10. If plugs are needed to plug old screw holes in cabinet face
frame, please contact Delfield Parts Department at (800)
733-8821, extension 12801.
Only for Models Ordered With Re-Hinging Option
1. Open door 90˚ and lift door straight up and off hinges.
2. Remove the metal screw covers on each door-side hinge
section by sliding it down and off.
3. Remove two outer screws that mount each hinge to door,
loosen the center screw, rotate hinge 180˚, reinstall outer
screws and retighten center screw.
4. Remove two screws that mount lock on top of door, turn
door up-side-down and remount lock to top of door.
5. Pry the plugs out of the hinge mounting holes on the side
opposite the current hinge locations and set them aside.
6. Remove the cabinet hinge screw covers by gently prying
them out with a small screwdriver.
7. Remove all three screws from each hinge and mount them
to the opposite side of the door opening. Press the plugs
removed in step 5 into the screw holes from the original
hinge locations.
8. Remove the plastic cam from the hinges by pulling straight
up, then rotating the cam 180˚ and pushing back into the
hinge.
9. Remount the door and check for proper closure and gasket
seal. Adjust hinges as needed. Once adjustment is verified,
remove the door, reinstall all hinge screw covers and set the
door back in place.
10. If additional plugs are needed due to loss or damage, please
contact Delfield Parts Department at (800) 733-8821, exten-
sion 12801.
