DeLaval SCB3, Instruction Book

Page: 16 / 26

1. Make sure that the wall is good enough for
stable installation of the DeLaval swinging
cow brush SCB3.
2. Measure and calculate the average height
of withers within the herd. The mounting
height of SCB depends on the average size
of cows (see X in Fig. 9). To match the
mounting height (Y) with corresponding X
size, see Ä Table "Average heights of with-
ers and corresponding mounting heights
for SCB" on page 16 .
Average heights of withers and corre-
sponding mounting heights for SCB
Centimetres Inches
X Y X Y
120 160 47.2 63.0
125 165 49.2 65.0
130 170 51.2 66.9
135 175 53.1 68.9
140 180 55.1 70.9
145 185 57.1 72.8
150 190 59.1 74.8
155 195 61.1 76.8
160 200 63.0 78.7
165 205 65.0 80.7
3. Determine the position of the bracket. For
correct measurements, use the separate
mounting stencil provided with the wall
mounting bracket.
4. Mark positions of four fixation holes on the
wall using the separate mounting stencil as
reference.
5. Drill four Ø12 mm holes.
6. Mount the brush using threaded (M12)
bolts. They should be cut at the length of
the wall thi 70 mm.
Put the bolts in the drilled holes, mount the
brush and fix it with washers and nuts.
Note! To support the assembly, it is rec-
ommended to add a plate reinforcement
connecting two screw joints at the other
side of the wall.
7. Remove the swing protection plates (see
Fig. 8).
8. Check the fixation after one week.
X
Y
Z
215127
Fig. 9: Determining the height of the wall mounting
bracket before the fixation.
X: Average height of withers
Y: Installation height of lower bracket
Z: 52 cm
215129
Fig. 10
DeLaval swinging cow brush SCB3
Installation
© DeLaval 2016.
2016-07-19, Version 5 16 (26) 84948801