Delabie TEMPOMATIC 4 443406, Installation Instructions, Page: 4 / 4

Auckland (Head Office)
20 Carr Rd, Three Kings
Auckland 1041
P: 09 624 1115
F: 09 624 1110
E: sales@macdonaldindustries.co.nz
Wellington
P: 04 569 8033
F: 04 569 8066
Christchurch
P: 03 348 2356
F: 03 348 2376
www.macdonaldindustries.co.nz
3/17
MAINTENANCE AND CLEANING
• Cleaning chrome Do not use abrasive,
chlorine or acid-based cleaning products.
Clean with soapy water using a cloth or a
sponge.
• Frost protection Drain the pipes and
operate the mixer several times to drain
any remaining water.
MAINTENANCE
• Mixer: regularly check (as often as
necessary) the temperature selector and
the mixer’s two internal seats on which the
mixing key turns. Replace as necessary.
Replacing the solenoid valve:
• Shut-off the hot and cold water supply.
• Deck-mounted models and wall-mounted
TEMPOMATIC 4: loosen the screw
(fig. D) using a 2.5mm Allen key with-
out removing it totally, and remove the cap
(fig. D) by rotating slightly downwards.
• Wall-mounted TEMPOMATIC 3: Loosen
the screw (fig. F) using a 2.5mm Allen
key without removing it totally, and remove
the spout (fig. F).
• Remove the electronic unit (fig. D, F)
and disconnect the connector (fig. D, F).
• Using a 17mm socket (fig. D, F) for
TEMPOMATIC 3, and 13mm for
TEMPOMATIC 4, unscrew the solenoid
valve (fig. D, F).
• Install the new solenoid valve and
carefully tighten, ensuring that the thread
is not damaged.
• Reconnect the connector (fig. D, F) to
the electronic unit without replacing the
unit.
• Reconnect the water supply and check that
the valve opens/closes by activating the
electronic cell. Check that the solenoid
valve is watertight inside the mixer body.
If there are any leaks, gently tighten the
solenoid valve.
• Replace the electronic unit and the cap.
• Deck-mounted models and wall-mounted
TEMPOMATIC 4: Carefully tighten the
screw (fig. D).
• Wall-mounted TEMPOMATIC 3 mural:
Carefully tighten the screws (fig. F) on
the wall-mounted TEMPOMATIC 3.
Replacing the 6V Lithium battery:
• Low battery life (fig. G, H), will prevent
the solenoid valve operating and cause the
LED, sited on the sensor on TEMPOMATIC
4 or on the TEMPOMATIC 3 electronic
model, to blink for 15 days.
• Using a 2.5mm Allen key: loosen the
screws (fig. G, H) without fully removing
them and remove the cap (fig. G, H) by
rotating slightly downwards.
• Remove the electronic unit (fig. G, H).
• Loosen the screw/s (fig. G, H) (1 screw
on the TEMPOMATIC 3, 2 screws on the
TEMPOMATIC 4) to change the battery,
leaving the washer in place.
• Replace the assembly, carefully tightening
the screws (fig. G, H) (taking care not to
damage the sensor).
11
13
12
14
15
16
17
15
11
12
18
11
13
14
19
11