Dekema AUSTROMAT 624, Operating Instructions Manual

Page: 84 / 155

5. User interface AUSTROMAT
®
624 / 644
84 Operating Instructions (Version 01/2012)
5.7.1.5. Network (optional)
NOTE:
This functionality is optional.
•
The options that are enabled for your firing furnace can be found in the menu
Setup > Furnace ID > Options (see section 5.7.2.1).
• You can find information on enabling options in section 7.5.
NOTE:
Consult section 4.4 about connecting the firing furnace with a network.
In the "Setup" menu, click the [Network] button. The following window appears with the network
settings for the firing furnace. The current addresses in the network are displayed.
Fig. 5-19 Setup > Network
Buttons
•
[OK]:
Accepts the settings and switches back to the "Setup" menu.
• [ESC]:
Closes the window and switches back to the "Setup" menu. The
changes will not be saved.
Change IP address Change an address as follows:
• Click on the corresponding address The alphanumeric keyboard
window appears.
Please note: The current IP address cannot be edited.
•
In the keyboard window, click on [Edit].
•
Enter the desired program number.
DHCP active Use the button to assign an IP address to the firing furnace from you
network server. An LED within the button indicates that the DHCP
function is active.
VNC active Use the button to configure the firing furnace to be controlled via a
VNC program. An LED within the button indicates that the VNC
function is active.