Page 5
7
After a few minutes, the water will start to
boil. The kettle switches off automatically
and On/ Off switch
G
moves upwards.
-The blue light goes off.
Note
If you want to stop the heating manually,
push the On/Off switch
G
upwards.
8
Disconnect the plug from the wall socket.
9
Take the water tank from the base
H
. Only
hold it by the handle
E
.
Caution
Do not open the lid
C
as hot water could
splash out. Make sure that no water
splashes onto the base
H
.
10
Pour the water from the spout
A
to the
cup or glass you want to use.
Notes
If you want to continue the boiling process,
repeat the procedure from 1 to 10.
Let the kettle cool down between each heat-
ing process.
Hints and Tips
The kettle is equipped with a calc filter
B
which filters out limestone and other
residues when the water is being poured out.
Use softened or filtered water to prevent lime
build-up.
Operation
Preparation
1
Remove all packaging and sticker
materials and dispose of them according to
the applicable legal regulation.
2
Before using the appliance for the first
time, clean all parts which come into contact
with water carefully. (See the “Cleaning and
care” section).
3
Completely roll out the power cord from the
rewind I on the bottom of the base
H
. Pass
the power cord through the slot on the base.
4
Fill the water tank with water.
5
Set the kettle on its base
H
. Make sure that
the kettle is sitting in an upright position and
that it is sitting on the base correctly and in a
stable position.
6
Pour out the hot water and rinse the kettle
with water. This will remove any remaining
manufacturing residues from the inside of
the water tank.
7
Clean kettle well before initial use and
discard water of first two boiling cycles.
Operation
1
Push the lid release button
D
on the kettle
to open the lid
C
.
-The lid
C
opens automatically.
2
Fill the water tank with water.
Notes
Do not place the water tank on the base
H
while filling it with water.
Never fill the water tank above the maximum
level indicator or below the minimum level
indicator.
3
Close the lid
C
until it clicks into place.
4
Place the water tank on the base
H
. Make
sure that it is sitting in an upright and stable
position.
5
Insert the plug into the wall socket.
6
Press down On/Off switch
G
.
-On/Off switch
G
illuminates blue and boiling
process begins.
Note
Lid
C
should always be closed during the
boiling process; otherwise the kettle will not
switch off automatically.
2
