Page 6
WARNING:
10 seconds after
operating the product at the
proper speed (1 or 2) stated in
the user manual, put the foods
into the feeding channel and start
juice extracting. Otherwise,
failures may arise in the product
that are not covered by the
warranty.
Preparation & assembly
3
1.
Place the dregs container to its seat on
the body. Install filter container onto the body
so that it will cover the dregs container.
2.
Place the filter onto the holder and push
downwards to install it in correct position.
3.
Place the transparent filter cover. Engage
the latches onto the cover and push them
against the body to lock the cover.
(Figure 1) Locking latch is open
(Figure 2) Locking latch is closed.
WARNING:
Your juicer will not
work if the lid is unlocked.
WARNING: Never insert your
fingers into the food supply
channel.
WARNING:
Do not operate the
juicer without the dregs container
fitted.
4.
Place the juice container at the juice outlet
and remove the cover.
5.
Plug the appliance in and run it at the
suitable speed level. Select low speed level
for fruits such as peach and apricot. If the
fruit is hard such as apple or carrot, select
high speed level.
6.
When using the pusher, align its groove
with the notch inside the food supply
channel. Push the food down with pusher.
7.
Do not apply too much pressure onto the
pusher if the fruits or vegetables are too big
or if the food supply channel is full. This will
affect the juicing performance and even stop
the juicer when it is forced too much. Break
the large foods into smaller pieces that can
fit into the supply channel. Place the sliced
foods into the supply channel and push
lightly with the pusher.
