Page 5
Assembly
2
Assembly of chassis & column unit
1.
Unscrew the 7-shape Bolt from the
Extension Pole. (Fig.1)
2.
Insert the extension pole into the chassis
and tighten the 7-shape Bolt (Fig.2)
3.
From the extension pole loosen the height
adjustment ring and adjust the internal pole
to the desired height. (Note: If you can’t find
the internal pole, it must inside the extension
pole. You can pull it out from the extension
pole.) (Fig.3)
4.
To attach the head unit to the internal
pole, loosen the thumb screw on the bottom
of the head unit. Place the head unit on the
internal pole and tighten the thumb
screw in alignment with the groove on the
internal pole. (Fig.4)
CAUTION:
Height adjustment ring must be
fully fastened before the assembly of the
motor section to the internal pole.
Grill & fan blade assembly
1.
Unscrew the spinner clockwise (or take
the spinner out from the bag) and the
plastic nut counter clockwise to remove both.
Fix the rear grill to the motor then tighten the
plastic nut. (Fig. 5)
2.
Insert the blade onto the shaft, and make
sure the rotor shaft pin is fitted into the
groove of the blade. Turn the spinner
counter clockwise to tighten the blade. (Fig.
6)
3.
Fasten the front grill and the rear grill by
means of the grill clip and then tighten the
fan grill locking screw and nut. (Fig. 7)
