Page 18
Igniting the gas burners
1. Keep the burner knob pressed in.
2. Turn the knob counter clockwise to the
large flame symbol.
The gas is ignited with the spark created.
3. Adjust the knob to the desired cooking
power.
Turning off the gas burners
Turn the keep warm zone knob to off (upper)
position.
1.
Gas shut
off safety
x
Push the knob inwards and turn it counter
clockwise to ignite.
x
After the gas ignites, keep the knob
pressed for 3-5 seconds more to engage
the safety system.
x
If the gas does not ignite after you press
and release the knob, repeat the same
procedure by keeping the knob pressed in
for 15 seconds.
DANGER
Risk of deflagration incase of
unburned gas!
Do not press the knob for longer
than 15 seconds if there was no
ignition.
Wait for one minute and then
repeat the ignition process.
IMPORTANT
Make sure that the control knob
is pressed in deep enough to
ensure that the flame failure
device will activate and operate
normally.
As a counter measure
against blow out due to
fluid overflows at burners
or should the flame
extinguish for whatever
reason, the flow of gas to
the burner will
automatically be
terminated.
Gas shut off safety system (in models
with thermic component)
Wrong centralizing of the burner
caps may result in a flash back
and cause burners to melt and
deform. (After cleaning the burner
cap ensure the cap is properly
located on to the flame spreaders.
See fitting burner caps).
Wrong control of the gas valves:
Gas valves must be controlled
from 90
°
to 210
°
(or 160
°
according to the gas valve model)
If flame is set from 0
°
to 90
°
the
burner will be below the minimum
output and may result in a flash
back and cause burners to melt
and deform.
The above user faults are not
covered by the warranty.
