Page 18
5.18 Cancelling the programme
Press and hold the Start / Pause / Cancel
button for 3 seconds. The Start symbol
flashes. The symbol of the step at which the
programme was cancelled remains lit. "End"
appears on the display and the programme
is cancelled.
5.19 Machine is in Rinse Hold mode
The Spin symbol flashes and the Pause
symbol illuminates when the machine is in
Rinse Hold mode.
If you want to spin your laundry when the
machine is in this mode:
Adjust the spin speed and press the Start /
Pause / Cancel button. The Pause symbol
disappears and the Start symbol appears.
The programme resumes, discharges the
water and spins the laundry.
If you only want to drain the water without
spinning:
Press the Start / Pause / Cancel button. The
Pause symbol disappears. The Start symbol
appears. The programme resumes and
discharges the water only.
5.20 End of programme
“End” appears on the display at the end of
the programme. The symbols of the
programme steps remain lit. The auxiliary
function, spin speed and temperature that
were selected at the beginning of the
programme remain selected.
6 Maintenance and cleaning
The service life of the machine can be
extended if it is cleaned at regular intervals.
Regular cleaning also helps to alleviate
possible problems.
6.1 Cleaning the detergent drawer
Clean the detergent drawer at regular
intervals (every 4-5 washing cycles) as
shown below in order to prevent the
accumulation of powder detergent over time.
1.Press the dotted point on the siphon in the
softener compartment and pull it towards
yourself until the compartment is removed
from the machine.
2. Wash the detergent drawer and the
siphon with plenty of lukewarm water in a
wash basin. Wear protective gloves or use
an appropriate brush to avoid skin contact
with the residues in the drawer whilst
cleaning.
3. Insert the drawer back into its place after
cleaning and make sure that it is properly
seated.
The detergent drawer of models in the range
may differ.
To open the loading door after you have
cancelled a programme and the water level
in the machine is above the loading door
opening, first turn the Programme Selection
knob to the Pump+Spin programme and
discharge the water in the machine.
If an excess amount of water and softener
mixture starts to accumulate in the softener
compartment, the siphon must be cleaned.
Lift the rear part of the siphon to remove it as
illustrated. After performing the above
mentioned cleaning procedures, replace the
siphon back into its seating and push its front
section downwards and ensure that the
locking tab engages.
