7
• In-Ceiling installation, 90 degrees to joists spaced 16" on-center (or more)
– Place template at least 1
1
/
4
" away from existing joists (to clear lock arms).
– Template dose not need to be centered between joists.
– Trace around template with pencil.
– Cut hole.
– Install framing material inside cavity, running 90° to existing joists,
leaving 9
7
/
8
" between frame sides.
See Diagram 5, page 12 for reference.
Gasket requirements and application
• There are two sizes of gasket strips included in the accessory pack with the
owner’s manual.
– 5 short gaskets.
– 2 long gaskets.
• For ALL installations where cavity depth is 4" or less, the gaskets are
to be applied as follows:
– 3 SHORT gaskets are to be applied across the back of the wooden
enclosure.
• For In-Ceiling and In-Wall installations where the side of the enclosure
ends against a joist, stud or installed framing material:
– One SHORT gasket is to be applied to each side of the enclosure that will
be against the framing material. The SHORT gasket is designed
to fit behind the bezel, between the lock arm openings.
– One LONG gasket is to be applied to each side of the enclosure that
will be against the framing material.
Connecting the speaker
• Run color-coded wires between the speaker cavity and amplifier
unit. When running the wires inside the ceiling to the opening, leave a
minimum of 18" of additional length in the cavity to facilitate speaker
connection.
• Fish wiring out of hole.
• Connect the speaker wires to the UIW RSS II taking care to make red to
red (+) and black to black (-) terminal connections.
• Refer to your amplifier or receiver loudspeaker wiring instructions, turn
off the unit and connect the speaker wires to the appropriate colored out-
put terminal on the unit, again making red to red (+) and black to black (-)
connections. This will ensure absolute phase throughout the system.
Summary of Contents for UIW RSS II
Page 9: ...Diagram 1 Diagram 2 9...
Page 10: ...Diagram 3 Diagram 4 10...
