6
"L3" is high gear position, fastest; "L1"
is low, speed is the slowest position, if
short press the button
will change
the gear position to L1, L2, L3 and L1,
press the button or 5 seconds without
operation will automatically keep the
gears position and quit the system.
Gear set has the memory function, next
time operation system will run the user
date automatically. When the battery is
full and loaded weight is less than 70
kilograms, the gear position speed is as
follows:
L1: maximum speed at about 20 km/h
L2: maximum speed at about 30 km/h
L3: maximum speed at about 40 km/h
Short press
button to enter a single
mileage display interface,
"TRIP" icon lit, numerical display area
shows four integers, such as "0123.5"
say the single mileage is123.5 km. In
the display interface of single mileage
long press
button 3 seconds, a
single mileage can be reset.
Short press
button to enter the
accumulated mileage display interface,
"ODO" icon lit, numerical display area
shows five integers, such as "12035"
say the accumulated mileage of 12035
kilometers. Accumulated mileage for the
total mileage of the vehicle, can not be
reset.
Short press
button to enter the
cycle count display interface, numerical
display area shows five integers, such
as "00016" say the battery charging and
discharging times is16. when the bat-
tery power is less than 30% of the total
electricity meter charging time again is
filled again. On cycle count display in-
terface short press the Short press
Short
mode button enter the time
display interface,
"TIME" icon lit. Initial time display for-
mat is "MM: SS", The before two num-
ber is minutes, after two number is sec-
onds, the time display format will
change to “HH:MM” format untill the
time display interface is “99:99” the
before two number is hours and the
after two is minutes.
Automatic shutdown
When the keys on the table is displayed
without operation and speed regulating
handle full relaxation (velocity is zero),
more than 90 seconds, save electricity
system will automatically shut down into
the state, Long press
the switch
button 3 seconds to boot.
Start
The activation method for this scooter
for the non-zero start, need a foot
stepped on the skateboard first, and the
other kick the ground a few times to
give the scooter a velocity, and then
immediately upon the regulating handle
to the scooter to accelerate the speed,
so to start the scooter. Scooter starts to
move speed regulating handle to adjust
speed.
MAINTENANCE
Lubrication
Need every six months in folding handel
clutch set using a small amount of lubri-
cating oil or lubricant to do mainte-
nance.
• Note: do not use the WD40 (rust-
proof oil) to lubrication product parts,
front and rear wheels don't lubrication,
if in doubt, consult your dealer.
Tire
When the brake performance began to
decline, adjust the brake line regulator
in order to achieve the required sensi-
tivity.
If the brake line after adjustment, The
braking performance is still poor, Or the
brake noise, please replace brake pads
by dealer.
This product is equipped with lithium
battery can repeat charging at least two
years 800 times, When each time with
electric range too short, lithium batter-
ies need to be replaced.
General troubleshooting
Check the listing
Summary of Contents for DF-SK8
