Introduction
The DX-500 Solar is a long range detection kit designed to protect the perimeter of properties, ranging from
residential areas to large commercial or industrial environments. The solar-powered, wireless nature of the sensors
means the kit is also suitable for use in rural environments with no access to electricity. The DX-500 Solar has an
operating range of 150m and each system can be added to with multiple sensors and receivers. The PIR sensors are
solar powered, fully waterproof and easy to install. Perfect for use on driveways, construction sites, rural properties
and entry points of any kind.
Contents
1 x DX-500 Solar Wireless Outdoor PIR Sensor
1 x Small screwdriver
Battery Installation/Replacement
This is solar powered via the top charging panel and a 3.7v lithium battery. The battery does not need replacing.
To activate, simply unscrew the rear cover and slide the switch to ON. Before first use you should charge your unit;
with the switch set to OFF leave it in direct sunlight for 6-8 hours. You should then switch back to ON and install the
unit; it will then take charge constantly during daylight hours, as long as the switch is ON. Turning the switch OFF
deactivates the motion sensor.
Operation & Pairing
The DX-500 Solar Wireless Outdoor PIR Sensor is compatible with the DX-500 Solar Wireless Perimeter Security Kit
or DX-500 Wireless Pager Receiver. Please follow the steps below:
DX-500 SOLAR WIRELESS PIR SENSOR
Additional PIR Sensor for the DX-500 Solar Kit Product Code: EL00225
defendersecurityproducts.co.uk
Screws and fixings
Instruction manual
To pair with the DX-500 Solar Wireless Perimeter Security Kit
Before pairing the Solar PIR Sensor with the existing Wireless Indoor
Receiver, choose your preferred melody on the Receiver by using the backward
and forward buttons to cycle through the options. Each Receiver has 50 different
melodies to choose from. This allows you to set different melodies for up to 50
different PIR Sensors, making it easy to identify which zone has been triggered.
Once you have chosen your desired melody you are ready to pair the Receiver with
the additional Solar PIR Sensor. Press and hold the volume button for five seconds,
until you hear a noise and the blue LED starts flashing. The Receiver is now in
pairing mode and you simply need activate the Solar PIR sensor whilst the Receiver
is within range (150m). To activate, simply wave your hand infront of the Sensor.
The desired melody should trigger, indicating pairing was successful. Pairing mode
lasts five seconds and will automatically end after this time, or when a pairing is
successful.
To reset the Receiver and remove all pairings, press and hold the forward button for
five seconds until you hear a noise and the blue LED flashes once. The Receiver has
now been reset and all existing pairings have been deleted.
To pair with the DX-500 Wireless Pager Receiver
Before pairing an Solar PIR Sensor with a Wireless Pager Receiver, choose your
preferred alert tone by using the music change button (located on the back of the
unit) to cycle through the options. Each Pager Receiver has 50 different melodies to
choose from. This allows you to set different melodies for different motion sensors,
making it easy to identify which zone has been triggered.
