Introduction
1.
Remove the protective rubber cap from probe.
2.
Power-up Gage by pressing the center navigation button.
3.
Verify Gage accuracy (pg.3).
4.
Place the probe FLAT on the surface to be measured such
that the tip of the probe reaches into the bottom of a profile
valley. HOLD STEADY. The Gage will BEEP twice and
display the measurement.
5.
Lift the probe from the surface between measurements.
The
PosiTector
Surface Profile Gage
(SPG)
is a hand-held
electronic instrument that measures the surface profile (peak-to-
valley height) of blasted steel, textured coatings and concrete
profile. It consists of a PosiTector body (Standard or Advanced) and
probe.
1
Press the button to power up the Gage. To conserve battery
life, the gage will automatically go to sleep after 5 minutes of
inactivity. While in
Sleep Mode
, the gage powers up significantly
faster— convenient when moving between parts or locations. The
gage will completely power off after 4 hours of inactivity.
Alternatively, select
Power Off
from the main menu. All settings
are retained.
Quick Start
Menu Operation
To access the Menu, power-up the gage, then press the center
navigation button . Either the keypad or touch screen can be
used to navigate the menu. If desired, touch screen functionality
can be disabled within the Setup menu (See
Touch
, pg. 5).
Select a menu option by touching it, or use the
and
but-
tons to highlight the desired option and press to select it.
On menus longer than one page, the current page number is
displayed below the menu name. Navigate between pages using
when the first menu item is selected, or
when the last
menu item is selected. If using touch, navigate between pages
by touching or , or by swiping up or down.
