www.defelsko.com
© 2020 DeFelsko Corporation USA All Rights Reserved
This manual is copyrighted with all rights reserved and may not be
reproduced or transmitted, in whole or part, by any means, without written
permission from DeFelsko Corporation.
DeFelsko, PosiSoft and PosiTector are trademarks of DeFelsko Corporation
registered in the U.S. and in other countries. Other brand or product names
are trademarks or registered trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is
accurate. DeFelsko is not responsible for printing or clerical errors.
Limited Warranty, Sole Remedy
and Limited Liability
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth
on its website: www.defelsko.com/terms
Returning for Service
Before returning the Gage for service…
1.
Install new or newly recharged batteries in the proper alignment
as shown within battery compartment.
2.
Clean the measurement anvils using the cleaning card (pg. 7).
3.
Perform a
Hard Reset
(pg. 9).
4.
Verify accuracy and operation (pg. 7)
5.
If issue is not resolved,
Update
(pg. 18) your
PosiTector
gage
body and re-attempt measurements.
IMPORTANT:
If these steps do not resolve the issue and the Gage must be
returned for service, please follow the instructions provided at
www.defelsko.com/service.
