5
SINGLE WAVELENGTH :
Repeatedly press and release
Button F
until the
desired wavelength is selected
(this single wavelength will be delivered for the entire
treatment duration)
then go to step 7.
DUAL - WAVE :
Repeatedly press and release
Button E
until the desired wavelength
combination is selected
(these two wavelengths will be delivered together for the entire
treatment duration)
then go to step 7.
TRI - WAVE :
Repeat step 4 and step 5. The three wavelengths selected, will cycle in
sequence as single colours for 2 minutes
(wavelength 1)
, 2 minutes
(wavelength 2)
then
one minute
(Near Infrared -
NIR
)
, until the end of the programme.
Set the desired treatment duration.
Button G
will decrease treatment time
(minimum
5 minutes)
whilst
Button
H
will increase it
(maximum 60 minutes)
. The recommended
treatment duration is 20 - 30 minutes, and can be used daily if required.
Connect the appropriate end of the ‘electricity supply cable’
(see page 3)
into power cable
Port C
at the front of the control panel, and plug the opposite end into the electric wall socket
or adapter,
Light B
will illuminate, indicating that power is being supplied to the control panel.
Connect the appropriate end of the ‘mask to control panel cable’
(see page 3)
into
Port A
at
the front of the control panel, and the opposite end into Power supply
Port 4
found at the chin
of the Mask
Press and hold
Button D
for 2-3 seconds, and release when you hear a short melody.
The LCD screen on the top of the control panel will illuminate. The control panel is now ready
for programming.
DÉESSE PRO
I N S T R U C T I O N S F O R U S E
S E T T I N G U P T H E M A S K
1.
2.
3.
C H O O S I N G Y O U R P R O G R A M M E &
T R E A T M E N T D U R A T I O N
4.
5.
6.
7.
