Deer Fence Access Gate
Installation Instructions
Deer Fence Access Gate Frame
Installation Instructions
5
STEP 1
Assemble the top of the gate first. Starting with
the top spreader pole (part L), slide two corner
elbows (part N) onto the ends. Make sure the
elbows are pushed in to the end of the pole.
Attach the corner elbows to the top spreader
pole using two self-tapping screws on each
elbow.
STEP 2
Determine where on the fence line you will
install your access gate and lay top spreader
pole here. Mark the placement for the two 9
feet side poles (part M) accordingly.
STEP 3
Dig holes where you marked for the 9 feet side
poles approximately 20 inches deep, allowing
for 88 inches of the post to be above ground.
STEP 4
Finish assembling the access gate frame
by attaching the 9 feet side poles to the top
spreader pole using one self-tapping screw on
each end.
STEP 5
Stand assembled gate frame upright and place in the previously dug post holes. Set
the poles in place with quick-dry concrete. Before securing the posts, ensure that the
gate is in line with the fence and the width of the opening of the gate frame is the same
at the top and bottom. Hang gate to frame using male hinges (part O).
