VISTA X INSTRUCTION MANUAL BY DEEPTECH
4
1.2.
Shaft assembly
1)
Make sure the levers and twist screw are loose on the middle shaft at both ends then
push and twist the lower stem and upper (control box) section into the middle shaft,
make sure the lower stem connects into the middle shaft at least 5-6 inches for now
and the upper (control box) section all the way into the middle shaft.
2)
Loosely tighten the twist the screw for now on the lower camlock that is at the lower
stem end
3)
Close the lever on the camlock, the lever should be easy close for now to allow enough
movement for the lower stem to be altered for size you desire and direction of the
coil.
4)
Repeat process 2 and 3 with the upper camlock that is towards the upper (control box)
section, but this time firmly tighten the twist screw and push the lever shut snug to
the camlock so the middle shaft holds firmly against the upper (control box) section,
if the camlock twists on the middle shaft tighten the Allen key screw shown in photo
3 in the red circle.
5)
Open the lower camlocks lever and adjust lower stem to your desired length to detect
comfortably then align the lower coil inline with the control box as shown in the photo,
you can now firmly tighten the twist screw and close the lever snug to the camlock, if
the camlock twists on the middle shaft then tighten the Allen key screw shown in
photo 3 in the red circle, now wrap the coil lead around the shaft up towards the
control box, you don't need this right to the shaft but you can't have the coil lead
loose also especially near the coil as this can cause false signals, but allow enough
length in the coil lead for there to be some movement of the coil at different angles.
6)
Connect/push the female coil lead connection into the male control box socket shown
in photo 7 but bare in mind you need to align the both parts correctly otherwise they
will not connect, now carefully screw the female coil lead connection sleeve to the
control box socket firmly but don't over tighten.
7)
Control box male connection
8)
Make sure the batteries are placed in the battery holder the correct way and touching
all connections at both ends, slide the battery holder into the battery compartment
with the connections towards the bottom of the battery compartment as shown in the
photo.
9)
Place and twist the battery compartment end cap back firm and secure.
10)
Bare in mind when altering the length of your lower stem that you don't trap the coil
lead under the lever as shown in the photo.
