DeDietrich VEKS7085, User Manual

Page: 44 / 100

EN-41
INSTALLATION INSTRUCTIONS AND DOOR
REVERSIBILITY
Installation instructions
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
1. See fig.A for the necessary attachment components.
2. Unscrew two screws at the top surface. (fig.D)
3. Peel the double sided tape at the bottom surface of trim flap
(1)
. Insert trim
flap
(1)
into slot and screw by 2 screws(6) to left / right side. (fig.E)
IMPORTANT NOTICE: Do not screw any screw to the middle.
4. Pass the power cord through ventilation shaft and position it so that the
appliance could be easily plugged in once it has been installed. (fig.B - fig.C)
5. Take out the trim gasket
4
located on the side panel of the appliance and
stick it on reverse side of the door hinges of the appliance. (fig.E - fig.F)
6. Raise the appliance and slide into the kitchen unit.
7. Push the appliance to the reverse side of the door hinges providing that the
trim gasket
2
covers the space between the appliance and the kitchen unit.
8. Align the front feet with front surface of the kitchen unit. (fig.G)
9. Screw the front feet by using screws
5
. (fig.G)
10. Screw trim flap
1
to kitchen unit using screws
5
. (fig.H)
11. Screw
guides
3
to appliance door with
screws
6
. (fig.I)
12. Lean appliance door to unit door as it is opened at right angle.
13. Slide
rails
4
into guides
3
aligning the groove . (fig.I)
14. Screw the rails
4
to the unit door with screws
5
. (fig.I)
15. Set 1~2 mm gap on handle side between unit itself and unit door by adjusting
guides
3
. That is vital for appliance performance. (fig.I)