Quick Start Guide
EN
Quick Start Guide
Prior to using you appliance you need to ensure the appliance has been installed in accordance with the installation
instructions within this guide. Particular attention should be paid to the ventilation requirements as this could affect
the performance of the appliance as well as the long term reliability.
Operation
Care should be taken to ensure that the pan / pans being used cover a minimum of 80% of the cookin g zone.
Place the pan on the zone you wish to use and turn on the zoneusing the corresponding “B” control. Set a power
level on the zone using the corresponding control “C”.
Noise
You may notice a clicking noise when either using multiple zones or a single zone on low power settings
(below level 5). This is normal and should not be considered a fault; it is the electronics of the appliance reg-
ulating the power delivery to the zones. You may notice a corresponding reduction of the bubbles in the base of the
pans on the hob, again this is normal.
Power sharing
The machine is manufactured with shared electronics controlling the cooking zones. The power delivered by
the independent electronics is split between the two zones. If “9” is selected on one zone the power is re-
duced on the other to”5” to ensure the maximum connected load is not breached. This is not a fault with the appli-
ance. When using either two zones on the same side ot the appliance together, you may notice a clicking and
alternating bubble pattern in the base of the cookware, this is normal.
Suitable cookware
If the display on the appliance flashes when set, this is an indication that either there is no pan on the zone
or, an unsuitable pan is being used. Please refer to the pan guide in the description section of this guide for
further details.
Controls Table
A
Timer “+” and “-” controls and display
B
On / off controls one per zone
C
Power “+” and “-” controls
D
Display
E
Lock Control
3
Summary of Contents for DTi714
Page 1: ...DTi714 Induction Hob...