Quick Start Guide
EN
Controls Table
A
Boil function
B
Tracker function
C
Continuum Cooking Zone Selectors
D
Timer displays
E
Power level display
F
individual zone selectors
G
Power “+” and “-” controls
H
Power pre-set controls
I
Timer “+” and “-” controls
J
Elapsed time function
K
Lock Control
3
Quick Start Guide
Prior to using you appliance you need to ensure the appliance has been installed in accordance with the installation
instructions within this guide. Particular attention should be paid to the ventilation requirements as this could affect
the performance of the appliance as well as the long term reliability.
Operation
Care should be taken to ensure that the pan / pans being used cover a minimum of 80% of the cooking zone.
Place the pan on the zone you wish to use and select the zone on the control panel using the selector controls “F”
or, if the entire zone is required “C”.
Select either a pre-set power level “H” or use the “+” or “-” controls to determine the desired power level. If you
wish to control more than one pan these should be selected in turn, noting the controls apply the power settings to
the last zone selected. This is shown by an indicator light adjacent to the zone selector “F”.
Noise
You may notice a clicking noise when either using multiple zones or a single zone on low power settings
(below level 7). This is normal and should not be considered a fault; it is the electronics of the appliance reg-
ulating the power delivery to the zones. You may notice a corresponding reduction of the bubbles in the
base of the pans on the hob, again this is normal.
Power sharing
The machine is manufactured with shared electronics controlling the cooking zones. The power delivered by
the independent electronics is split between the two zones. If “boost” is selected on one zone the power is
reduced on the other to ensure the maximum connected load is not breached. This is not a fault with the
appliance.
You may wish to select “Boost” on the Continuum setting, it is worth noting that you may notice a clicking and alter-
nating bubble pattern in the base of the cookware, this is normal.
Suitable cookware
If the display on the appliance flashes when set, this is an indication that either there is no pan on the zone
or, an unsuitable pan is being used. Please refer to the pan guide in the description section of this guide for
further details.
Summary of Contents for DTi1053
Page 1: ...DTi1053 Induction Hob...
