6
located inside the appliance, on the left
wall down. R600a is a non-polluting gas
that does not harm the ozone layer and
whose contribution to the greenhouse
effect is virtually zero.
Installation
WARNING:
Correct installation
of your device complying with the rules
that are given in this installation guide
and use will allow you to keep your food
in good conditions and with optimized
energy consumption.
·
If your appliance has wheels,
remember that they are only used to
facilitate small movements. Do not move
on longer distance.
·
Make an initial cleaning before
connecting your device to the mains.
Before any maintenance, disconnect
your device. Do not pull the power cord
but directly enter the profile.
·
Place the unit in a dry and ventilated
room.
·
Avoid balconies, porches, decks;
excessive heat in summer and cold in
winter could prevent proper operation
of your device, or even damage.
·
Do not place it near a heat source
such as radiator or oven for example.
·
Keep a minimum distance between
your refrigerator and other furniture: 3
to 5 cm on the sides and 10 cm above
for good air circulation around the unit.
·
Place the appliance at a suitable
distance from the wall using the
spacers if they provided in the
accessory bag.
·
Your appliance has been designed for
optimum performance in a room
temperature. We then say that it is
designed for a special "climate class".
This climate class is clearly stated on
the rating plate located inside your
appliance, on the left wall down.
Beyond these temperatures, the
performance of your appliance may be
reduced.
Classe
Temperature
SN
from + 10°C to + 32°C
N
from + 16°C to + 32°C
ST
from + 16°C to + 38°C
T
from + 16°C to + 43°C
Advice:
After installation of your appliance, set
its feet so that it is slightly tilted
backwards, it will facilitate the closing of
the door.
Before putting food, clean the interior
and exterior of your appliance with
bicarbonate of soda dissolved in water
(1 tablespoon of bicarbonate for 4 litres
of water). Do not use alcohol, abrasive
powders or detergents which could
damage the surfaces. (See chapter
"Cleaning your appliance").
ELECTRICAL CONNECTION
The electrical installation must comply
with the applicable standards and must
be able to withstand the maximum
power indicated on the rating plate.
The plug must be properly grounded.
We cannot be held responsible for any
incident caused by defective electrical
installation.
Electrical Installation Tips
• Do not use extension cable or adapter
or power strip.
• Never remove the grounding.
• The socket must be easily accessible
but out of reach of children.
In case of doubt, ask to your installer.
Your device is compliant with EU
directives and their modifications.
ENERGY SAVING
To reduce the power consumption of
Summary of Contents for DRL1624J
Page 102: ......
