DeDietrich DMG7129X, User Manual, Page: 7 / 20

7
installed in its housing.
Ensure that:
- the electrical installation has sufficient power
(16 Amps),
If the electrical installation in your home
requires a modification to connect the
appliance, call a qualified electrician.
During maintenance, the appliance must be
disconnected from the mains, the fuses must
be cut off or removed.
Warning:
The safety wire (green-yellow) is
connected to the appliance’s terminal
and must be connected to the installation’s
earth.
If the oven malfunctions in any way,
unplug the appliance or remove the fuse
corresponding to the sector where the
oven is hooked up.
Warning:
We cannot accept liability for any
accident or incident resulting from non-
existent, defective or incorrect grounding.
UNPACKING
When you receive the appliance, unpack it or
have it unpacked immediately. Check its
general appearance. Make a note of any
reservations on the delivery slip and keep a
copy. Remove all protective packaging. Check
the appliance’s characteristics on the
nameplate and make sure you comply
(fig.
A) .
CHOICE OF LOCATION AND BUILDING IN
This appliance must be installed in a cabinet
column as shown in the installation diagram
(fig. B-C-D-E) .
Do not use your appliance immediately (wait
approximately 1 to 2 hours) after moving it
from a cold location to a hot location, as the
condensation may cause a malfunction.
Centre the oven in the unit so as to ensure a
minimum distance of 10 mm between the
appliance and the surrounding unit. The
material of the unit supporting the appliance
must be heat-resistant (or covered with a
heat-resistant material).
For greater stability, attach the oven to the unit
with 2 screws through the holes provided in
the side panels.
ELECTRICAL CONNECTION
Important:
This appliance should only be
installed by professionals and qualified
technicians.
The appliance must be correctly built in to
ensure electrical safety. Electrical connections
should be made before the appliance is
•
1
INSTALLATION