7
Ensure that:
- the circuit has sufficient power (16 Amps),
If the electrical installation in your home
requires a modification to connect the
appliance, call a qualified electrician.
During maintenance, the appliance must be
disconnected from the mains, the fuses must
be cut off or removed.
Warning:
The safety wire (green-yellow) is
connected to the appliance’s
terminal
and must be connected to the installation’s
earth.
If the oven malfunctions in any way,
unplug it or remove the fuse for the circuit
where the oven is installed.
Warning:
We cannot accept liability for any
accident or incident resulting from non-
existent, defective or incorrect earthing.
UNPACKING
When you receive the appliance, unpack it or
have it unpacked immediately. Check its
general appearance. Make a note of any
reservations on the delivery slip and keep a
copy. Remove all protective packing. Check
the appliance’s characteristics on the
nameplate and make sure you comply
(fig.
A)
.
CHOICE OF LOCATION AND BUILDING IN
This appliance must be installed in a cabinet
column as shown in the installation diagram
(fig. B-C-D-E)
.
Do not use your appliance immediately (wait
approximately 1 to 2 hours) after moving it
from a cold location to a hot location, as the
condensation may cause a malfunction.
Centre the oven in the cabinet so as to ensure
a minimum gap of 10mm between the
appliance and the surrounding unit. The unit
supporting the appliance must be made of
heat-resistant material (or covered with a
heat-resistant material).
For greater stability, attach the oven to the unit
with 2 screws through the holes provided on
the side panels.
ELECTRICAL CONNECTION
Important:
Only qualified installers and
technicians should install electrical
appliances.
The appliance must be correctly fitted into its
housing to ensure electrical safety. The
electrical connections should be made before
the appliance is installed in its housing.
•
1
INSTALLATION
