DeDietrich DLZ1854I, User Manual

Page: 81 / 132

81
EN
 Press the START/PAUSE button to start
the selected cycle.

Once a programme is selected the
programme selector remains stationary on
the selected programme till cycle ends.

"End"
will appear in the display at the
end of the program and the DOOR
LOCKED light will go off, it is now
possible to open the door.
 Switch off the washing machine by
turning the selector to OFF .
 Press to start the selected cycle.
PAUSING THE MACHINE
 Keep the
START/PAUSE
button pressed
for about 2 seconds (some light indicators
and the residual time display will flash,
showing that the machine is paused).
 Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE PROGRAMME

To cancel the programme, set the
selector to the OFF position.
 Wait
2 minutes
until the safety device
unlocks the door.

This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours .
DELAY START button
For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.
When the START/PAUSE button has
been pressed, the appliance can take
few seconds before it starts working.
Close the door BEFORE selecting the
button START/PAUSE.
START/PAUSE button
The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
When the programme selector is turned
the display lights up to show the settings
for the programme selected.
For energy saving, at the end of the
cycle or with an inactivity period, the
display level contrast will decrease.
N.B.: To switch the machine off, turn
the programme selector to the OFF
position.
PROGRAMME selector with OFF
position
WARNING:
Don’t touch the display while inserting
the plug because the machines
calibrates the systems during the first
seconds: touching the display, the
machine couldn’t work property. In
this case, remove the plug and repeat
the operation.