DeDietrich DHD1122G Manual To Installation Download Page 10

Page: 10 / 12

To cancel the delayed stop, press the same button and

the delay function will be deactivated.

2.1.3 - LIGHT

Press the

button briefly to switch the hood’s ha-

logen light on or off.

Pressing and holding the

button will change the

intensity.

2.1.4 - EOLYSE FUNCTION

A short press of the

button starts the hood running

silently at a reduced speed for one hour. The

button

is lit and the

indicator flashes.

At the end of this time, the hood stops on its own. To

stop the function, press

once more.

Programming the Eolyse function

A long press on the

button activates programming.

The

button flashes alternately with the

button,

indicating the start of programming.

Each short press on the

button increases the

eolysis time by one hour (from 1 hour to a maximum of
9 hours) and after 9, this display goes back to 1. The
hood will run silently at a reduced speed for the

selected time. The

button flashes alternately with

the

button (the number of successive flashes is

the number of hours selected).
Programming is confirmed automatically after 25 se-

conds or by a short press on

. (The

button

flashes alternately with the

button).

Programming is confirmed by pressing the

button;

press it a second time to cancel.

2.1.5 - EVACUATION / RECYCLE MODE

A long press (more than 2 sec) on the

and

but-

tons allows you to select Evacuation or Recycle mode.

The

and

buttons are lit and the

but-

ton flashes. A short press on

selects recycle mode

(the

button flashes and the

button is off.

A short press on

selects evacuation mode (the

button flashes and the

button is off.

A short press on

confirms the configuration (or au-

tomatic set after 10 sec).
The hood’s default mode is evacuation.

2 3

2.1.6 - FILTER CARTRIDGE SATURATED

The

button flashes (1 short flash) for 2 minutes after

the hood stops to signal that the cartridge filters must

be cleaned (see section “Cleaning the cartridge filter”).

Give a long press (more than 2 sec) on

to unlock

the “saturation” function.

The

button flashes ( 2 short flashes) for 2 minutes

after the hood stops, to signal that the charcoal filters

must be cleaned (see section “Changing the charcoal

filter”).

Give a long press (more than 2 sec) on

to unlock

the “saturation” function.

FAN AUTO STOP

If you forget to turn the hood off, it will turn itself off au-

tomatically after 9 hours.

LIGHT AUTO STOP

If you forget to turn off the light on your hood, it will turn

itself off automatically after 9 hours.

Caring for &
cleaning

Always unplug the hood before cleaning it or

performing other maintenance acts. Regular mainte-
nance of your appliance is a guarantee of proper
functioning, good performance and durability.
Failure to respect the guidelines for cleaning the appli-
ance and filters may cause fires. Please care

fully adhere

to the maintenance recommendations.

CLEANING THE FILTER CARTRIDGES

They must be cleaned after approximately 30 hours of
use or at least once a month. Use a brush, hot water
and mild detergent. Rinse and dry them thoroughly
before returning them to the hood.
•

Dismantling the filter cartridge

— Turn the built-in filter cartridge handle.
— Tilt the filter cartridge downward.

3.1