DeDietrich C 340 280, Installation And User Manual

Page: 120 / 220

10.4.4 Control unit signals
Tab.108 Navigation for basic installer level
Level Menu path
Basic installer
> Installation Setup > CU-GH13 > Submenu
(1)
> Parameters, counters, signals > Signals
(1) See the column "Submenu" in the following table for the correct navigation. The signals are grouped in specific functionalities.
Tab.109 Signals at basic installer level
Code Display text Description Range Submenu
AM010 Pump speed The current pump speed 0 - 100 % Gas fired ap­
pliance
AM012 Status Appliance Current main status of the appliance.
See
Status and sub-status,
page 144
Status infor­
mation
System Func­
tionality
AM014 Sub status Appli­
ance
Current sub status of the appliance.
See
Status and sub-status,
page 144
Status infor­
mation
System Func­
tionality
AM015 Pump running? Is the pump running? 0 = Inactive
1 = Active
Gas fired ap­
pliance
AM016 System Flow Temp Flow temperature of appliance. -327.68 - 327.67 °C Zone manag­
er
Producer Ge­
neric
Gas fired ap­
pliance
Prod. manag­
er bridge
AM017 T heat exchanger The temperature of heat exchanger -25 - 150 °C Gas fired ap­
pliance
AM018 T return Return temperature of appliance. The
temperature of the water entering the ap­
pliance.
-327.68 - 327.67 °C Zone manag­
er
Gas fired ap­
pliance
AM019 Water pressure Water pressure of the primary circuit. 0 - 25.5 bar Gas fired ap­
pliance
AM027 Outside tempera­
ture
Instantaneous outside temperature -70 - 70 °C Outdoor tem­
perature
Gas fired ap­
pliance
AM028 0to10Vinput Value of the 0 to 10 Volt input. Meaning
is dependant on the current input func­
tion setting.
0 - 25 V 0-10 volt input
AM040 Control tempera­
ture
Temperature used for hot water control
algorithms.
-327.68 - 327.67 °C Gas fired ap­
pliance
AM046 Internet T.Outside Outside temperature received from an
internet source
-70 - 70 °C Outdoor tem­
perature
AM091 SeasonMode Seasonal mode active (summer / winter) 0 = Winter
1 = Frost protection
2 = Summer neutral band
3 = Summer
Outdoor tem­
perature
AM101 Internal setpoint Internal system flow temperature set­
point
0 - 120 °C Gas fired ap­
pliance
CM030 Zone RoomTem­
perature
Measure of the room temperature of the
zone
0 - 50 °C Direct zone
10 Settings
120 C 340 / C 640 7762666 - v.02 - 29092020