IMPORTANT INFORMATION
•
THIS SHOWER PANEL IS DESIGNED FOR FLAT WALL MOUNTING ONLY!
•
We recommend that the shower panel’s mounting brackets are secured into a wall stud. If unable to, prior to installation make
sure that wall can support a load of 12kg.
•
Do not drop the back flow filters on both ends of the control valve when you remove the cap.
•
Rinse all debris from the water supply system, otherwise the cartridge inside the thermostat valve will be damaged.
•
The HOT and COLD water hoses are connected with ½” BSP fittings. The male connector on the wall must be running parallel
to the wall, a 90° elbow may be required to achieve this.
•
Before beginning installation, please inspect your shower panel to ensure there is no damage. If you find any abnormality,
please immediately return the product with all its original packaging to your licensed dealer.
•
Please leave your Shower Panel in its original packaging until you are ready for the installation.
INSTALLATION
* PRIOR TO INSTALLATION MAKE SURE YOUR HOT & COLD WATER VALVES ARE CLOSED
STEP 1: REMOVE & INSPECT THE SHOWER PANEL
* THE IDEAL DISTANCE BETWEEN YOU & THE RAINFALL SHOWER IS 20
CM
STEP 2: INSTALLATION OF YOUR SHOWER PANEL TO THE WALL
1. To attach the mounting
brackets to the wall, measure
the distance between the two
supports on the back of the
shower panel, this should be
roughly 915mm.
For the ideal mounting
position refer to the
technical drawings on the
opposite page>>
4. Connect the HOT and COLD
water pipes and thoroughly
test for any leaks.
2. Drill holes in the wall for
the two brackets according to
the distance obtained in the
step before.
3. Insert the plastic pegs and
screw them into the wall,
while holding the bracket in
place. Use a level to ensure
the brackets are straight.
Avoid over tightening the
screws.
5. Mount the shower
panel onto the wall brackets,
ensuring they are resting in
the correct positions on the
back of the panel. Once the
panel is secure and in place
run a line of silicone down
each side of the panel.
6.
Assemble the hand shower
and attach it to the shower
panel.
915
mm
