INSTALLATION STEPS
1. Prior to installation remove the basin from the box and inspect for any transport damage or visible defects.
2. Use the basin as a guide to line up the position of the basin on the bench top. Mark the centre point of the waste hole. Mark the position of the
tap ware at this point too, to ensure;
∙ THERE IS ADEQUATE SPACE BEHIND THE BASIN & TAP WARE ∙ THE BASIN FITS ON THE BENCH TOP & DOESN’T HANG OVER THE FRONT
3. Re-check the final position of your basin. Ensure there are no obstacles below the bench top which might impact the cutting of this hole.
Use the 100mm hole saw to drill a hole for the waste to sit in.
4. Place the basin in position, ensuring it is level & fix it into place in the bench top using a bead of silicone right the way around the basin base
(allow the silicone to set for a minimum of 24 hours). Be sure to clean any excess silicone from around the basin base and bench top.
5. Under the bench top connect the basin to the plumbing. Connect the plug and waste to the waste pipe using an approved waste trap.
6. Install and connect your tap ware as per its separate installation instructions.
7. Ensure there are no leaks and the water drains fully and correctly from the basin.
PLEASE NOTE
∙ IF USING WALL MOUNTED TAP WARE, CONSIDER THE LENGTH OF THE OUTLET TO THE BASIN ON THE BENCH TOP
∙ IF THE TAP WARE IS BENCH MOUNTED, ALLOW SUFFICIENT WIDTH ON THE BENCH TOP FOR FITTING THE TAP WARE
ADDITIONAL TOOLS REQUIRED FOR INSTALLATION
ENSURE YOU HAVE ALL TOOLS & ADDITIONAL PARTS REQUIRED FOR THE COMPLETE INSTALLATION OF YOUR BASIN BEFORE COMMENCING.
100mm Hole saw
Adjusble Wrench
Warm soapy water and a soft cloth for cleaning
Pencil
Level
Tape measure
Silicone Gun
Your basin tap ware
Drill
TOP VIEW STEP 2. & 3.
FRONT VIEW STEP 4.
SIDE VIEW STEP 5.
Waste Pipe
Stop Valve
Decina uses premium vitreous china, finished with a protective Nano Glaze coating which is resistant to most things it may come into contact with.
However naked flames, cigarettes or strong chemicals should be avoided and removed immediately.
To preserve the white, high gloss surface Decina recommends the following:
∙ CLEAN USING A SOFT MOIST CLOTH, WARM SOAPY WATER & MILD LIQUID DETERGENTS ONLY
∙ DO NOT USE STRONG BLEACHING AGENTS, POWDERS, PASTES, CREAMS, CHEMICALS, WINDOW CLEANING SPRAYS, ABRASIVE
CLEANERS & ABRASIVE/HARD CLOTHES
∙ IN CASE ACID LIQUIDS PENETRATE ON THE SURFACE REMOVE THEM IMMEDIATELY WITH A SOFT CLOTH
CARING FOR YOUR BASIN
All dimensions are nominal & subject to manufacturing tolerances & may vary +/-5mm, therefore we strongly recommend installation does not occur until after delivery. Decina reserves the right
to modify or change models without notice. For further information and for warranty T&C’s, please visit decina.com.au or call 1300 332 462.
Copyright Oct 2019. Decina Bathroomware Pty Ltd. ABN 39845 084 033
WARRANTY TERMS & CONDITIONS
All Decina products are manufactured to the highest standards and guaranteed to be free of defects, subject to T&C’s. In addition to the statutory rights
given under Australian Consumer Law, Decina offers the following extended warranty periods from the date of purchase or handover:
PRODUCT
WARRANTY
TERMS
ELINEA LUXE Counter Top Basin - Premium Vitreous China
10 YEARS
Replacement Products or Parts
To view Decina’s full warranty & returns pollicys or to make a warranty claim, please visit the Decina website decina.com.au/warranty-claim/
1300 DECINA
DECINA.COM.AU
