MDEK1001 Kit User Manual
© Decawave 2017
OP-MDEK1001-System-User-Manual-1.0
Page 25
setting needs to be saved by tapping
in the upper-right of the screen.
Figure 17: Device Details Screen
– Anchor & Tag
The following parameters are displayed:
Device Name
ID
Device ID
BLE
Device Bluetooth address
NODE TYPE:
Set Node to be either “Anchor” or “Tag”. All devices will have a
factory-default of
‘tag’ mode. Once the configuration is changed, and saved, the
device will remember the new setting.
NETWORK:
Add the Node to a network (either a previously created network or, if
none exists, the option to create a new network will appear)
UWB:
‘off’, ‘passive’ or ‘active’.
o
Set to ‘active’ to range in the network.
o
Set to ‘passive’ if used as a listener.
If in tag mode:
o
NORMAL UPDATE RATE:
Set the location update rate. The default is 10 Hz
(calculates a location 10 times per second) but can be changed to other rates
o
STATIONARY UPDATE RATE:
Set the location update rate to be used when
the device is stationary (detected by the motion sensor)
UWB FIRMWARE UPDATE:
Allows firmware update to propagate to this device
LED:
Disables/enables the LEDs on the board. May be used by a user to help
identify which device is referenced.
If in anchor mode:
o
INITIATOR
Configure this anchor as an initiator. At least one of the
anchors must be an initiator in the network. The initiator will start and control
the network
