Sp
eedSp
y™
U
ser
’s & I
nstalla
tion M
anual
9
3. Components
3.1 Removing the Battery
Start by removing the three battery plate wing nuts and the battery
retaining plate . The battery is positioned sideways with the battery
terminals on the right . Stand the enclosure on a flat surface with the
battery upright . Next carefully pull the battery from the enclosure .
3.2 Installing and Attaching The Battery
Ensure that the three battery
plate wing nuts and battery
retaining plate have been
removed . Stand the enclosure
on a flat surface with the
battery cavity upright .
Position the battery sideways
with the battery terminals on
the right and slide/push the
battery back between the guide tubes . Replace the battery retaining
plate and secure using the three wing nuts . Tighten the wing nuts
enough to secure the battery and prevent movement . Connect the
male/female white colored Molex™ connectors .
3.3 Battery Charger
The charger is designed
for mounting . However we
recommend that you use it
as a
desktop device
. Charge
the batteries at the office to
minimize having to remove
the SpeedSpy™ enclosure . If
required, the charger can be
mounted to the SpeedSpy™
base plate and attached to the
optional charger connections on
the interconnect circuit board (See Figure 3 .4) . The battery charger
has a 5 A fuse .
Figure 3.2
Wing nut locations
Figure 3.3
Battery Charger
S702-39
