07
Note: Do not clean with alcohol or solvent cleanser. Never
immerse the housing in water for cleaning.
Detach the metal funnel by turning it clockwise, get rid of coffee
residue inside, then you can clean it with cleanser, but at last
you must rinse with clear water.
Clean all the attachments in the water and dry thoroughly.
CLEANING MINERAL DEPOSITS
1. Fill the tank with water and descaler to the MAX level ( the scale
of water and descaler is 4:1, the detail refers to the instruction of
descaler. Please use “household descaler”, you can use the citric
acid (obtainable from chemist’s or drug stores) instead of the
descaler (the one hundred parts of water and three parts of citric
acid).
2. According to the program of pre-heating, put the metal funnel
(no coffee powder in it) and jug in place. Brewing water per
“ PRE-HEATING”.
3. After pressing the power switch one time, and then its red lamp
will be flashing, you should press the coffee switch, maker sure
the coffee/steam selector , when there is water flowing out and
close the pump, and wait for a moment, the coffee maker begins
to be heated.
4. When the lamp in power switch is illuminated, it shows the
heating is finished. Pressing the coffee switch and make two cups
coffee (about 2Oz). Then close the pump and wait for 5s.
5. Press the steam selector, the indicator in the steam switch will
be flashing, waiting for until the indicator in the steam selector
is illuminated. Make steam for 2 min by turning the steam
control knob, then turn the steam control knob to “o” position
to stop making steam. Press the Power switch for stop the unit
immediately, make the descalers deposit in the unit at least 15
minutes.
6. Restart the unit and repeat the steps of 4-6 at least 3 times.
7. Then press the coffee/steam selector , the lamp in coffee switch
will be illuminated, then press the coffee switch to brew until no
descaler is left.
8. Then brew coffee (no coffee powder) with tap water in the MAX
level, repeat the steps of 4-6 for 3 times (it is unnecessary to wait
for 15 minutes in step of 6), then brew until no water is left in the
tank.
9. Repeat the step of 9 at least 3 times to make sure the piping is clean.
10. Follow the operation as below to cancel the descaling warning
after finish descaling. Hold and press the coffee switch and steam
switch for 3 seconds at the same time under the standby mode,
and then their corresponding indicators quickly blink for 3 times,
which means the descaling warning is canceled and the working
cycle is zeroed.
