Chapter 2
Operating Information
This chapter provides the operating information necessary to perform day-
to-day printer operations. It covers typical tasks such as adding paper,
selecting an output tray, or powering the printer on and off. This chapter
also covers manual feed operation for all print media.
2.1 Powering the Printer On
Power the printer on using the following procedure.
1. Press the power switch on the back of the printer to the | (ON) position.
MLO-005116 (Figure 2-1; 16 picas)
You should observe the following when you power on the printer:
— All control panel indicators light for a moment.
— The Ready indicator flashes and the display reads
02 WARMING UP (assuming that the printer has cooled below
operating temperature before it is powered on).
Operating Information
2–1
Summary of Contents for 220240
