Override key
To open the save the following list is necessary:
1. Override Key
2. Phillip
’
s Head Screw
-
Driver
CAUTION : REMOVE THE BATTERY.
Do NOT pull or tug on key-
pad face or wires. It is crucial that these wires stay intact & con-
nected for the lock to operate. Please note: you are liable for
any damages that occur to the lock while accessing the override
key slot.
LOCATING THE OVERRIDE KEY
The Override Key is concealed yet easy to access in case of an
emergency or loss of code.
a. Remove the battery.
b. Looking at the keypad, locate the bubble sticker; top, center.
c. Remove this bubble sticker. * Place the bubble sticker aside,
face down, so to not stick to anything
* Do not lose bubble sticker
* See Figure A
d. Using a Phillip
’
s Head screw
-
driver, remove the screw connec-
ting the keypad face to the keypad collar.
*See Figure B
*Keypad Face : the keypad & surrounding chrome edge
* Keypad Collar : the black housing that is attached to the safe.
Houses the battery, wires & electronic component e. Carefully
let the keypad face hang with wires still attached.
a. With the keypad face removed, locate the override key slot
inside the keypad collar, on the left. * See Figure E
b. Using your key, with the larger/longer notches facing UP, place
the key into the slot.
*You may need to angle the key slightly in order for it to slide in
properly. *See Figure D
c. Make sure the key slides completely into the slot, the pin
fitting into the end of the key. * See Figure E
d. Once key is snug, turn counter clockwise [left] to the 8 o
’
clock
position. Your safe will be unlocked. * See Figure F
REMOVING THE OVERRIDE KEY
a. Make sure the safe is in the locked position
* You will not be able to turn the key if the safe is in the unlocked
position. b.Once the safe is locked, turn the key clockwise [right]
and pull out of slot.
REINSTALL THE KEYPAD FACE
CAUTION : Be EXTREMELY careful with the wiring. Do NOT pinch
wires in between the keypad face & the keypad collar.
a. With your fingers, carefully grip the keypad face, holding it so
the face is out & the numbers are right side
-
up.
b. Re
-
attach to the keypad collar by inserting bottom first, so the
notch connects, then carefully press/push into keypad collar ca-
sing.
c. Once the keypad face is snug in place, screw the keypad face
back to the keypad collar & replace the bubble sticker.
