TP10413002 Rev.03
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
Page 2 of 2
Model: EV8650
Quick User Guide
Display Messages
Display Reason
Solution
CLEAr
Sensors in hopper, stacker and or track sensor obscured by notes or dirt.
Remove notes and / or clean sensors.
FEEd
Note jammed in hopper, stuck together or too thick for thickness setting.
Remove notes from hopper. Ensure that they are unstuck before
re-feeding. Alter note thickness setting if necessary. (see Feed Gap
Setting)
HALF
A half note has been detected by the machine.
Remove the notes from the stacker. Remove suspect note(s) from the
bundle and repeat the count. When the notes are re-fed, the count display
returns to zero or displays the total when the stacker was last emptied.
Press START/STOP to continue.
JA
Notes are jammed in the note transport.
Switch Machine off. Open the machine by pressing the release buttons as
shown on page 8 of the user guide. Remove the notes carefully. Close the
machine and switch on.
dEn
A note of a different size has been detected.
Examine the notes, replace note or re-feed.
CF
A Counterfeit Suspect note has been detected.
Examine the notes, replace note or re-feed.
rFEEd
The machine has stopped as a result of a note handling problem.
Remove all notes from the stacker and repeat the count.
tAbLE
The machine has stopped as a result of a invalid denominational sized
note.
Remove all notes from the stacker, remove the invalid domination note
and repeat count.
LASt
A note from the previous bundle is left in the transport.
Remove notes and recommence count.
GuLP
Three or more notes has passed through the machine together.
Remove all the notes from the stacker. Remove the suspect from bundle
and repeat the count. Maybe adjust the feed gap setting.
oVEr
Only appears in value mode and shows that a higher value than originally
requested has been dispensed.
Replace notes with a lower value in the hopper.
FAULt
A fault has been detected in the machine.
Switch off the machine and contact your local agent’s service engineer.
CLEAn
Dust from the banknotes is obstructing the machine’s sensors
Clean the machine internally.
see user guide page 9
CLEAn add
This machine has stopped as a result of dirt on the double detect bearings
or rollers.
Carry out the cleaning procedure as shown.
See user guide page 9.
CLEAn dEt
This machine has stopped as a result of dirt on one of the detectors
Carry out the cleaning procedure as shown.
See user guide page 9.
Lid
The top of the machine has been opened to allow for a jammed note to be
removed or for cleaning.
Ensure the lid is closed correctly and that both release latches are secure.
Press the START/STOP key to clear the display.
nEAr
In dispense mode, the dispense amount cannot be completed because
the denomination set is larger than the remaining value required.
Check and clean the transport.
Remove all notes and repeat the count.
n_rdY
det
A selected detector failed to start properly. The icon for the affected
detector will flash.
This may be too dirt in the transport.
Check and clean the transport.
Remove all the notes and repeat the count.
Clean Detector
