Vector530UserManualVer122.doc
- 16 -
June 14, 2005
10.
Connect P5 (DB9) of the wiring harness to the meter pigtail.
11.
On the meter pigtail join the Green, White and Red wires together and insulate the wires.
12.
Connect P2 (DB9) to the smart meter DB9.
13.
Connect P1 DB25 connector to the back of the MDT. DO NOT over tighten the set
screws.
14.
Connect the MDT to the mount.
15.
Tie wrap any loose cabling up under the dash so that the driver or passengers will not
step on it and cause unnecessary strain.
16.
Perform Set Up and Tuning procedures if they have not yet been performed.
METER INTERFACE
1.
Connect the Green, White and Red wires of the meter pigtail together and insulate the
wires.
2.
Connect the meter pigtail to P5 of the wiring harness.
3.
The BLACK wire is the meter status wire.
4.
Connect P2 of the wiring harness to the DB9 serial port of the Smart meter.
ONLY if a Smart Meter is used.
GPS ANTENNA MOUNTING AND CABLE ROUTING
1.
A suggested mounting place for the GPS antenna is under the top kight light.
2.
Ensure the top light is not coated with a metallic paint/coloring.
3.
Ensure the top of the Antenna is not obstructed by metal, and is not too close to the bulbs.
4.
The cable can then be run through the same hole as the existing wires
5.
Ensure the cable is not pinched or cut in any way, and is threaded down the passenger
side of the window pillar.
6.
It is suggested the GPS antenna should not be too close to the GPRS antenna.
