EN
12
Installation instructions
9
Wind both front feet up and roll the product out
of position.
a
Place the packing material in the location
diagonally opposite the front roller that
lifts off the floor.
b
Make sure the packaging material stays in
place when the product is pushed back
into position.
c
Ideally, the packing material is large enough to
rest against the back wall so as to prevent
it moving when the cabinet is pushed into
position.
10
Roll the refrigerator back into position and adjust
front rollers as per step 5 (check alignment and
door closing action are satisfactory).
a
Make small adjustments to front rollers where
necessary.
b
Firmly screw front feet down on the ground.
c
Check that the product is stable (all 4 feet are
on the floor). If not, return to step 7 and repeat
8, 9 and 10.
d
Place toe grille on the bottom of the
refrigerator (refer to step 5d).
Wall behind
refrigerator
This foot lifts off the floor when pushing
gently on the top front of the refrigerator
Packing material goes under rear roller
diagonally opposite front foot that lifts
Fig.7 Stabilizing your refrigerator
Summary of Contents for RF195A
Page 2: ...English Page 1 44 Français Page 45 89 ...
Page 46: ...44 US CA FR ...
