11
LEAK TESTING & LIGHTING INSTRUCTIONS
WARNING:
Do not smoke while leak testing. Extinguish all open flames.
Make a soap solution of one part liquid
detergent, and one part water. Never leak test
with an open flame. For LP units, check with a
full cylinder. Make sure all control valves are
in the “OFF” position. Turn the gas supply
“ON”. Check all connections from the supply
line (Fig. 02), or LP cylinder (Fig. 03) up to the
manifold pipe assembly (Fig. 06). Apply the
soap solution around the connection with a
spray bottle, brush, or rag. Soap bubbles will
appear where leak is present.
If a leak is
present, turn off gas supply, tighten any
leaking fittings, turn gas on, and recheck.
WARNING: IMPORTANT!
Inspect the gas supply piping or hose prior to turning the gas “ON”. If there is
evidence of cuts, wear or abrasion, it must be replaced prior to use. Do not
use the Professional Side Burner if the odor of gas is present. Turn the control
knob to “OFF”, then turn on the gas supply. If using LP, is there gas in the
tank? Always keep your face and body as far away from the burner as
possible when lighting.
LIGHTING INSTRUCTIONS
Remove the burner cover, or any cooking utensils from
the burner grate.
Push and turn the control knob
counterclockwise to the “HI” position. This will start the
gas flowing. Push and hold the ignition button next to
the burner knob. You’ll hear a snapping sound. At the
same time a spark will be provided at the burner
ignition. It may be necessary to engage the ignition
button until gas has filled the line. If the smell of gas is
detected and the ignition is not functioning,
immediately turn the control knob “OFF”.
Allow 5
minutes for any accumulated gas to dissipate, then see
the following section for “Match Lighting”.
REAR
FRONT
IGNITION
FIG. 07 BGA132-BI Shown
FIG.06
Ignition
Control
Knob