Instruction manual VE1646 STAND FAN 18 INCHES
dcg16.it
10
PRODUCT ASSEMBLY
ASSEMBLE OF BASE
• Set the column in place on the base and secure it using the “L”
screw with washer while also engaging the counterweight.
• Make sure column and base and counterweight are firmly coupled.
• Loosen and remove the Height Adjustment nut from the top of the
underpart Tube.
• Insert the upperpart tube into underpart, tighten with the height
adjustment knob,
• Loosen and remove the Height Adjustment nut from the top of the
upperpart Tube.
• Insert the neck and the motor part into the upper part column and
tighten with the height adjustment nut,
• If necessary, you can only set the underpart column use as the floor
fan. Make sure the Set Screw is tightly secured.
ASSEMBLE OF BLADE AND GRILLE
• Unscrew the plastic mounting nut from the front of the motor
housing by rotating it anticlockwise.
• Position the rear grille against the front of the motor housing with
the handle uppermost, ensuing that the locating pegs on the motor
housing are engaged correctly in the holes of the rear grille.
• Tighten the Rear Grille Mounting Nut clockwise. DO NOT
OVERTIGHTEN IT.
• Push the fan blade onto the motor shaft, locating the slot at the back
of the blade on the drive pin that passes through the motor shaft.
• Tighten the blade cap by turning it anticlockwise.
• Position the front grille against the rear grille so that the holes in
the rims that accept the small nut and bolt are in line. Insert the
bolt through the holes and screw on the nut. Do not fully tighten at
the stage.
• Push the grille retaining clips into position ensuring that they
engage correctly on the rim of the grille.
