Configuration
15
6.
The configuration program should now start and after a
few seconds display a sign-on screen.
If nothing appears on your screen, press ESC.
Refer to
on using the configuration program.
Telnet Configuration
NOTE: For telnet to work, there MUST be compatible IP
addresses in both the PC and the EtherPoll!
1.
Install the EtherPoll into your LAN as described in Chapter
2. Ensure that the EtherPoll is powered on.
2.
Connect to the EtherPoll with the command:
telnet IP_Address Port_number
Where:
IP_Address
is the IP address of the EtherPoll
Port_number
(for configuration) is 8000.
For example, if the default IP address had not been
changed, then you would enter the command:
telnet 192.168.1.1 8000
If you can't connect
If the EtherPoll does not respond, check the following:
•
The EtherPoll is properly installed, LAN connections
are OK, and it is powered ON.
•
Check that your PC is using a compatible
IP Address
and
Network Mask
.
In Windows, the IP Address and Network Mask can be
checked by using
Control Panel-Network
to examine the
Summary of Contents for EtherPoll
