Introduction
Parity...........................................................................................22
Data Bits......................................................................................22
Stop Bits......................................................................................22
DCD Input Control......................................................................22
Client Dial Mode.........................................................................22
Set port dialing mode [AT Dial Hardware, (DCD) Dial, or Nailed Up] In AT dial mode, modem-like AT
commands are used to connect to a remote server. In DCD dial, the client automatically connects to the
remote server when the DCD signal goes high. In nailed-up mode, the DCD signal is ignored, and as
soon as the client is activated, it connects to the remote server.. .22
Mode...........................................................................................22
Client's Remote IP Address.........................................................22
Server Ethernet Port....................................................................22
Main Menu Option 4.
Advanced Configuration Screen..................................................23
1. Transmit Timer........................................................................23
M. Timer Mode...........................................................................23
2. Block Size...............................................................................24
3. Flow Control OFF Buffer Level..............................................24
4. Flow Control ON Buffer Level................................................24
5. Line_Terminator_Character.....................................................24
6. Transmit_on_LT_Char............................................................24
7. Server End-of-Line Filter........................................................24
8. Client Local Character Echo....................................................24
9. Keep-Alive Frequency............................................................24
Setting this parameter to a non zero value will enable a Keep-Alive feature in the Unit. When the Unit is
in Client mode, it will send Keep-Alive messages to the server at the specified frequency when the link
between the client and server is idle. When the Unit is in Server mode, it will close the connection if the
link is idle for more than 3.5 times the Keep-Alive Frequency. The Telnet modes work differently: the
Server end sends Telnet NOPs, and the Client end times out. [0=OFF, 1-32767 seconds].....................25
Main Menu Option 5.
Display Settings...........................................................................26
Main Menu Option 6.
Reset Configuration to Default....................................................27
Main Menu Option 7.
Save and Exit...............................................................................27
Main Menu Option 8.
SNMP Configuration...................................................................27
Contact Person............................................................................27
Device Name...............................................................................27
Physical Location........................................................................27
SNMP Community......................................................................27
Main Menu Option 9.
Exit without Saving.....................................................................28
Chapter 5
Web-Based Configuration.....................................29
Overview............................................................................29
Administrative Maintenance...............................................30
Maintenance.......................................................................30
Actions................................................................................30
iii
