DCB BROADCAST POLLING FRAD BPF-2 BU, Manual

Page: 15 / 28

15
5.3 Using the Network Management port
To activate the NMP, press the ENTER key. When you see AT
YOUR COMMAND >> , the NMP is active and ready for your
commands. Type H <Enter> to display the command set.
5.4 Commands
5.4.1 Help (H or ?)
COMMAND LOCAL REMOTE PARAGRAPH
Show: Config SC RSC# 5.4.2
Port Map SM RSM# 5.4.3
FR Status SS RSS# 5.4.4
Change: Port Config CP RCP# 5.4.5
Port Map CM 5.4.6
Delay Timeout CD RCD# 5.4.7
FR Config FR 5.4.8
Config Internal DSU CN 5.4.9
Config Backup Modem CBM 5.4.10
Config Backup Number CBN 5.4.11
Set ID ID RID# 5.4.12
Set Password PW 5.4.13
Activity Counters/Zero AC/Z RAC#/RZ# 5.4.14
Test Tools TT 5.4.18
Type TY RTY# 5.4.15
Repeat Last Command * 5.4.16
Disconnect NMP BYE 5.4.17
This Help screen shows the choice of commands available. The
commands allow you to display the selected options, configure the
BPF-BU, and perform many different diagnostic functions. The #
character in the remote commands represents the DLCI number of
the Host BPF unit and must be included with the command.
5.4.2 Show (Port) Configuration
The Show Config (SC) command shows the current port configuration
settings for either the local or the remote (RSC#) ports. Port numbers
may be included with this command to limit the display range. If no
port numbers are included, settings for all ports are shown. Use this
command to verify proper port configuration.