OPERATION
REMOVE ALL DEBRIS FROM THE ITEMS TO BE WASHED BEFORE PLACING THEM INTO THE BASKET.
CLOSE THE DOOR, SELECT THE WASHING
CYCLE TIME SWITCH
2` OR 3` MINUTE - PRESS THE
CYCLE START SWITCH
- THE CYCLE
LAMP WILL COME ON.
AT THE END OF THE
CYCLE THE CYCLE LAMP WILL GO OUT.
OPEN THE DOOR AND PULL OUT THE BASKET - ALLOW EXCESS WATER TO RUN OFF BEFORE REMOVING.
PREPARATION
CHECK THE
DRAIN PLUG
IS
PUSHED
FIRMLY IN PLACE AND THE
FILTER BOWL
IS POSITIONED INTO THE
SURFACE FILTER
.
CHECK THE
DETERGENT
( RED ) AND
RINSE AID
( CLEAR ) SUPPLY TUBES, WITH
FOOT VALVES
- ARE SUBMERGED IN
SUFFICIENT PRODUCT.
CHECK THE DOOR IS CLOSED AND PRESS THE
POWER
SWITCH
- THE POWER GREEN LAMP WILL COME ON.
ALLOW 30 mins FOR THE MACHINE TO FILL WITH WATER AND REACH THE CORRECT WASHING TEMPERATURE.THE
MACHINE READY
LAMP
WILL COME ON.
OPERATING AND MAINTENANCE INSTRUCTIONS
PG50 D / PD50A D
ROUTINE MAINTENANCE
AT THE END OF A SESSION TURN OFF THE
POWER SWITCH.
DO NOT REMOVE ANY
FILTERS
AT THIS STAGE.
REMOVE THE
DRAIN PLUG
- THE WASH TANK WILL EMPTY. MACHINES FITTED WITH DRAIN PUMP WILL AUTOMATICALLY START TO
PUMP THE WATER OUT.
CLEAN AROUND THE WASH TANK - DOOR SURROUNDS AND HINGES WITH AN 'ADDIS'’ TYPE WASHING UP BRUSH.
COLLECT THE DEBRIS INTO THE
FILTER BOWL
AND REMOVE FROM THE WASH TANK. REMOVE THE
SURFACE FILTER
AND CLEAN
THOROUGHLY.
CLEAN AROUND THE LOWER WASH TANK
- DO NOT ALLOW DEBRIS TO GO DOWN THE
OUTLET HOLE
AS THIS MAY DAMAGE YOUR
MACHINE.
DO NOT USE CHLORIDE CONTAINING BASED CLEANING SOLUTIONS OR ABRASIVES WHEN CLEANING THE WASH TANK.
REGULARLY CHECK
RINSE JETS
AND
WASH JETS
ARE CLEAR OF DEBRIS OR LIME SCALE - REMOVE IF NECESSARY BY UNSCREWING
THE
RINSE ARM NUT
THAT HOLDS THE
RINSE ARM
IN PLACE - REMOVE THE
RINSE PIN
THAT HOLDS THE
WASH ARM
IN PLACE - CLEAN
BOTH THOROUGHLY AND REASSEMBLE.
REMEMBER TO REPLACE BOTH THE
SURFACE FILTER
,
FILTER BOWL
AND
DRAIN PLUG
.
POWER
SWITCH
CYCLE START
SWITCH
MACHINE
READY
LAMP
(OPTIONAL)
REMOVE DRAIN PLUG AND SWITCH THE MACHINE
OFF TO START THE AUTOMATIC DRAIN PUMP
CYCLE TIME
SWITCH
CYCLE
SELECTION
LAMP
WATER SOFTENER
REMEMBER TO REGENERATE THE EXTERNAL WATER SOFTENER IF FITTED REGULARLY. ENSURE THAT THE WATER VALVES
ARE TURNED BACK ON TO SUPPLY THE MACHINE WITH FULL MAINS PRESSURE SOFTENED WATER.
OUTLET HOLE
FILTER BOWL
DRAIN PLUG
SURFACE FILTER
WASH ARM
FOOT VALVES FOR
CHEMICAL
CONTAINER TUBES
RINSE ARM NUT
RINSE JETS
WASH JETS
RINSE PIN
RINSE ARM
WASHING
CYCLE LAMP
SERVICE CALLS TO RECTIFY FAULTS CAUSED BY `THE LACK OF ROUTINE MAINTENANCE` WILL BE CHARGED FORAND YOUR WARRANTY MAY BE AFFECTED
www.directcatering.co.uk
