LIVE FILTERS CAN SET TO ONE OF THREE FILTER LIFT SELECTIONS:
This sets the amount of time a live filter remains in effect before it becomes disengaged. The 3 Live
Filters settings are:
•
Live Filter Lift Off
– The filter remains in effect until all other available filters are in use and
it is needed again in a new position. The filter acts in a “round robin” capacity rotating in
line to address problems as they occur.
•
Live Filter Lift 10 Minutes
– The filter remains in place for 10 minutes, then checks to see
if it is still needed before it releases and is available for use again.
•
Live Filter Lift 1 Hour
– The filter remains in place for 1 hour, then checks to see if it is
still needed before it releases and is available for use again.
TO SELECT LIVE FILTER LIFT SETTINGS:
1.
On power up, press and hold channel 1 AFS button until the Channel 1 meters show every
other LED lit.
2.
Once the AFS button is released, the various modes can be selected.
3.
Pressing the Channel 1 AFS button cycles through the menus. This is indicated by changes
in the LED’s on the Channel 1 output meters.
4.
Press the Channel 1 AFS button until it lights up the
Second LED
on the Channel 1 output
Meter indicating that you are in the
Live Filter Lift Selection mode
.
5.
Pressing the Channel 2 AFS allows you to toggle between the three settings indicated by
LED’s on Channel 2 output meter.
Live Filter Lift Off
(1st LED)
Live Filter Lift 10 Minutes
(2nd LED)
Live Filter Lift one Hour
(3rd LED)
6
. Pressing and holding the Channel 1 AFS button will allow you to exit the power up menus,
or
proceed to instruction #4 below in “Front Panel Control Lock Out Feature.”
CHANNEL 2
Live Filter Lift Time Menu
Live Filter Lift Off
Live Filter Lift Shor
t
Live Filter Lift Long
