10
total fall distance is the
distance measured from
the onset of a fall to the
point where the fall is
arrested. A number of
factors can influence the
total fall distance
including; user's weight,
anchorage location
relative to the fall (swing
fall), body support with a
sliding D-ring, etc. With
the anchorage located
directly overhead, it is
recommended that at
least 2 ft. of clearance be
maintained between the
work level and the nearest
obstruction in the fall path. See Figure 7.
D. SHARP EDGES: Avoid working where the rope will be in contact
with or abrade against sharp edges. If working with this equipment
around sharp edges is unavoidable, provide protection by using a
heavy pad over the exposed sharp edge.
E. RESCUE: Should a fall occur, the employer must have a rescue
plan and the ability to implement it.
WARNING: Read and follow manufacturer's instructions for associated
equipment (full body harness, etc.) used in your rescue and positioning
system.
IMPORTANT: For special (custom) versions of this product, follow the
instructions herein. If enclosed, see attached supplement for additional
instructions to be followed when using a custom RPD.
3.3
BODY SUPPORT: When using DBI/SALA’s RPD, it is recommended
that a work-seat or boatswain's chair be used. A full body harness
should also be worn for connection to the independent personal fall
protection system. The D-ring on the back between the shoulders (dorsal
D-ring) should be used to connect the personal fall protection system.
IMPORTANT: Body belts are not allowed for free fall situations. Body belts
increase the risk of injury during fall arrest in comparison to a full body
harness. Limited suspension time and the potential for improperly wearing a
body belt may result in added danger to the user’s health.
Figure 7 - Swing Falls
