6
D. PHYSICAL AND ENVIRONMENTAL HAZARDS: Use of this
equipment in areas containing physical or environmental hazards
may require that additional precautions be taken to reduce the
possibility of damage to this equipment or injury to the user.
Hazards may include, but are not limited to; high heat (welding
metal cutting); strong or caustic chemicals; corrosive environments
(seawater); high voltage power lines; explosive or toxic gases;
moving machinery; or sharp edges. Contact DBI/SALA if you have
any questions about the application of this equipment in areas
where physical or environmental hazards are present.
E. TRAINING: This equipment is to be installed and used by persons
who have been trained in its correct application and use.
1.3
Refer to national standards, including; ANSI Z359.1, ANSI A10.14,
ANSI Z117.1, and applicable local, state, and federal (OSHA)
requirements, including 29 CFR 1910.146, for more information on the
application of this and associated equipment.
2.0
SYSTEM REQUIREMENTS
2.1
COMPATIBILITY OF COMPONENTS: DBI/SALA equipment is
designed for use with DBI/SALA approved components and
subsystems only. Substitutions or replacements made with non-
approved components or subsystems may jeopardize compatibility of
equipment and may effect the safety and reliability of the complete
system.
2.2
COMPATIBILITY OF CONNECTORS: Connectors are considered to
be compatible with connecting elements when they have been
designed to work together in such a way that their sizes and shapes
do not cause their gate mechanisms to inadvertently open regardless
of how they become oriented. Contact DBI/SALA if you have any
questions about compatibility.
Connectors (hooks, carabiners, and D-rings) must be capable of
supporting at least 5,000 lbs. (22kN). Connectors must be compatible
with the anchorage or other system components. Do not use
equipment that is not compatible. Non-compatible connectors may
unintentionally disengage. See Figure 3. Connectors must be
compatible in size, shape, and strength. Self locking snap hooks and
carabiners are required by ANSI Z359.1 and OSHA.
2.3
MAKING CONNECTIONS: Only use self-locking snap hooks and
carabiners with this equipment. Only use connectors that are suitable
to each application. Ensure all connections are compatible in size,
Summary of Contents for 8001717
