www.dbtechnologies.com
VIO L210
3
Rev 1.0 cod. 420120248Q
- Fasten the two enclosures using the quick-release
pins of the upper VIO L210.
- Check that all the pins are properly inserted and
locked before other mounting steps.
- Remove the rear pins and put the swing rear
bracket in the final position as shown.
CHECK PERIODICALLY THE INTEGRITY AND THE
FUNCTIONALITY OF THE ENCLOSURE, OF THE
PINS AND OF THE BRACKETS, FOR A SAFE
INSTALLATION. MAKE SURE THAT THE PINS SECURE
PROPERLY THE MODULES AND THAT THEY ARE FULLY
LOCKED.
- Insert the swing rear bracket of the
upper enclosure into the related
housing of the lower one.
- Choose the desired splay angle
between the two enclosures.
- If you need a flown
installation, only one
pin is required to
secure
the
rear
bracket. Fasten one of
the two rear pins in
the desired angle with
the
rear
bracket
inserted in, and let the
second one in the
position
“PIN
HOLDER”.
- If you need a stacked
installation,
it
is
mandatory to use both
the pins to secure the
rear bracket. Fasten
one of the two pins in
the
desired
angle,
with the rear bracket
inserted in. Lift the
rear of the upper
enclosure
to
the
maximum
height
allowed by the first
pin, and fasten the second pin in the related “ANGLE
LOCK” position. Then release the upper enclosure and
check that the rear bracket leans on the second pin,
fastened in the correct position.
