www.dbtechnologies.com
info@dbtechnologies
‐
aeb.com
SYA
10
Rev
1.1
cod.
420120308Q
3) Connections, controls, first turn on
All the connections and controls are in the amplifier
panel side:
CH1
:
1
–Audio Combo Input (for XLR or TRS connectors)
2
–Line/Mic selector
3
–Mic/Line Volume Control
CH2
:
4
–Audio Input (Balanced / TRS)
5
–Line Volume control
CH3 (
Bluetooth
)
:
6
–BT status sync LED
7
–BT Volume Control
MASTER SECTION
8
–DSP Preset switch
9
–Balanced audio output
10
–Link/Mix switch
11
–Master Volume with control LEDs
MAINS SECTION
12
–VDE MAINS INPUT (with fuse)
13
–ON-OFF SWITCH
a) Connect the audio input (
1
). The combo connector
allows a TRS or XLR connection. In case of a dynamic
microphone, plug it and select “Mic” in the Audio input
sensitivity switch (
2
). In the other cases check that the
switch is set on “Line”. Adjust the level of Volume (
3
).
b) Connect a second input, depending on the kind of
connection (XLR/TRS), then adjust the related volume
level.
c) If needed, enable with the switch (7) the Bluetooth
receiver. Pair it with a visible device (ex. a MP3 reader).
d) If you need to link SYA 10 to another one, please use
a cable with XLR connectors (not supplied). Connect
the Link output (
9
) of the first, to the balanced Input
(
1
) of the second one. In the second loudspeaker,
please check that Selector (
2
) is set on “Line” position
and that Volume (
3
) is set to the correct value.
e) Set properly the DSP preset switch (
8
), choosing
between “Playback”, ”Flat”, Bass Boost” or “Wedge”
configuration.
e) Plug properly the mains VDE input cable (supplied)
in the related input (
12
). Check that the audio source is
set on the minimum level. Then switch the POWER
switch (
13
) to “ON” position. Increase gradually the
volume of the audio source to the desired level.
Check the site
www.dbtechnologies.com
for further
information, for added accessories and for the
complete user manual!
