E6BE FUNCITONS
3
CENTER FREQUENCY:
This control allows you to select the frequency you want the E6BE
bass restoration circuit to enhance.
FREQUENCY BANDWIDTH:
This control allows you to adjust the range of frequencies from
your center point.
All the way to the left will include the maximum frequencies to enhance,
while all the way to the right will enhance only a limited amount of frequencies near your
CENTER FREQUENCY.
OUTPUT GAIN CONTROL:
This control allows for you to control the amount of signal you
are sending through the RCA OUTPUTS to your amplifier(s). It is important to note that the
E6BE has a built in line driver capable of sending 9 volts of signal output to your amplifier(s).
GROUND ISOLATION:
Alternator whine may appear in the system because the source unit
and amplifier may use different grounds.
To help in this situation, we have provided alternative
grounding options have been provided.
TURN SYSTEM OFF BEFORE SWITCHING THIS IN
RCA INPUT:
In normal cases you will leave the switch in the BALANCED position. In some
systems the source unit may look for a ground through the RCA connections. In this event
you would switch the selection to UNBALANCED.
INPUT:
RCA’s from source unit
OUTPUT:
RCA’s from the E6BE connect to the inputs of your amplifier(s).
REMOTE:
The E6BE Digital Bass Optimizer dash mount control connects here.
This remote
allows for complete control of your audible subwoofer level along with a LED indicator which
brightens as you increase bass enhancement.
REM / 12V / GND:
-REM:
Connects to a 12V+ switched source.
-12V:
Connects to a 12V constant source. (1 amp in-line fuse is required)
-GND:
Connects to a chassis ground.
NORMAL SELECTION.
1.
2.
3.
4.
5.
6.
7.
8.
9.
